Tubes cleaner, 10L

€49.80tax excl.VAT incl.: €60.26

Tax excluded

Descaler circuit and piping, lime scale remover and clay pipes, boilers, primary circuits, heat exchangers etc.

PESO DEL EMBALAJE: Peso

Quantity

Request a quote Chat on WhatsApp

Security

100% secure payment. Your purchases protected with SSL and trusted methods Visa, MasterCard, PayPal

Fast and guaranteed delivery

We deliver to mainland Spain, Balearic & Canary Islands, Portugal and other countries.

Return policy

Exchange or refund guaranteed according to legal standards and for defective products.

REGISTRATIONS:

Product registered with the National Institute of Toxicology.

PROPERTIES: Equipped with high wetting power, it penetrates through pores and cracks, breaking down and detaching lime and dirt, exerting a chemical reaction that slowly dissolves them. Acid multi-cleaner.

TECHNICAL CHARACTERISTICS:

Special blend of various mineral acids, activated with compatible surfactants in a strong acidic medium and emulsifiers that allow the cleaning solution to penetrate even the most occluded areas. Balanced formulation including corrosion inhibitors.

Density: 1.057 g/L
HCl: >20%
Other acids: Contains.
Anionic and non-ionic surfactants: Contains.
Flammability: No.
Aggressiveness: Exists in concentrated product. Towards metals and in dilutions of use, it is attenuated by the corrosion inhibitors it contains.
Acidity: 1 g requires 26-28 mL of 0.1N NaOH for neutralization. Phenolphthalein indicator.
Coadjuvant ingredients: Amino acetic resins, glycols, ethoxylated fatty alcohols.

APPLICATIONS:

For cleaning pipes, heat exchangers, boiler primaries, etc., with sludge, lime, and rust deposits that are dismantled or can be immersed in the product in sections. Cleaning PIPE SECTIONS. Elimination of lime deposits.

INSTRUCTIONS FOR USE:

Empty the pipe to be cleaned, seal it, and refill with pure product (as is) or with a water and product mixture in a ratio of 10 to 20% depending on the amount of dirt to be removed. Allow to act for at least 5 hours. Scrub if necessary. After that time, empty and rinse the pipe thoroughly with cold pressurized water. If the section or heat exchanger can be dismantled, perform the cleaning procedure by immersion in a 20-30% solution of the product in water. THIS VERSION HAS A HIGH FOAM CONTENT AND SHOULD NOT BE USED IN OPERATING CIRCUITS AS IT WOULD PRODUCE A LARGE AMOUNT OF FOAM. FOR SUCH CLEANING, USE OUR QUIM.

RECOMMENDATIONS:

The product/water ratio may vary depending on the dirt to be removed. Thoroughly saturate the surface with the solution. THIS VERSION HAS A HIGH FOAM CONTENT AND SHOULD NOT BE USED IN OPERATING CIRCUITS AS IT WOULD PRODUCE A LARGE AMOUNT OF FOAM. FOR SUCH CLEANING, USE OUR QUIM. IMPORTANT: products supplied by Lubricalia are guaranteed against manufacturing defects. The information, recommendations, methods of use and dosages given in this data sheet are indicative and refer to general use: they do not replace the product's safety data sheet, which is supplied with the goods and must be consulted before handling. As application conditions vary from case to case, we always recommend testing on a small, inconspicuous area first. This document may be updated without prior notice.